AI-100 Fixed Gas Detector
The general-purpose fixed detector for area monitoring, wired back to a gas monitor panel for alarms and interlocks.
EnquirePermanently installed detectors that watch an area continuously and trip an alarm before anyone notices a smell. Flameproof housings where the classification requires them.

Continuous toxic, combustible and oxygen monitoring for hazardous areas.
The sensor changes with the gas. The build quality, the calibration and the service commitment do not.
The general-purpose fixed detector for area monitoring, wired back to a gas monitor panel for alarms and interlocks.
Enquire
Continuous monitoring of one target gas, toxic, combustible, oxygen or VOC, with local display, high and low alarm thresholds, and 4–20 mA and RS485 out. Flameproof Ex d ⅡC T6 Gb, IP66.
EnquireTell us the gas and the range. If it is on this list we have a sensor for it, and if it is not, ask anyway.
A handheld instrument tells you the atmosphere was safe when somebody looked. A fixed detector tells you it has stayed safe since, and shuts something down when it has not.
One sensor per detector, chosen for the gas on site, in a flameproof body rated for Zone 1 and Zone 2.
| Detection principle | Catalytic combustion, electrochemical, infrared, PID or semiconductor |
|---|---|
| Detectable gases | Toxic, flammable and explosive, oxygen, TVOC |
| Gas options | CO, H₂S, O₂, NH₃, O₃, Cl₂, H₂, NO₂, SO₂, CH₂O, EtO, C₆H₆, C₇H₈, HCN, AsH₃, PH₃, HF, Br₂, CS₂, CH₄, CO₂, VOC (PID) |
| Resolution | 0.01 / 0.1 / 1 |
| Accuracy | ≤ 3% FS |
| Explosion-proof grade | Ex d ⅡC T6 Gb |
| Protection | IP66 |
| Output | 4–20 mA, RS485 |
| Pressure range | 86 – 106 kPa |
| Relative humidity | ≤ 95% |
| Power supply | 24 V DC ± 12 V |
| Target gas | Which gas, and whether you need more than one point |
|---|---|
| Measuring range | Percent LEL, ppm or percent volume |
| Area classification | Safe area, or the zone and gas group for a flameproof body |
| Mounting | Wall, pole or duct, and the height relative to gas density |
| Output required | 4–20 mA, relay, RS485 Modbus, or a combination |
| Panel | Whether detectors report to an AI-50 panel or straight to your DCS |




We will specify the sensor, the enclosure and the panel, and quote the calibration cycle with it.